A Think Again Media Group publication
On This Day Quiz

Explorer 1 and the first US satellite launch

Explorer 1: the detector, the radio logs and the radiation belts

By Phil Springer, Editor · Published · On This Day Quiz

Explorer 1: the detector, the radio logs and the radiation belts

Explorer 1 reached orbit on January 31, 1958, carrying a radiation detector that registered fewer cosmic rays than expected. James Van Allen suspected that an exceptionally intense radiation environment had overwhelmed the instrument. A small count could therefore mean that the detector was saturated. NASA's preserved Smithsonian data sheet records that interpretation, while George H. Ludwig's 1961 radiation report describes the receiving network and the later analysis. The satellite's scientific importance grew from the relationship between an instrument's behavior and the environment it was meant to measure.

The launch occurred at 10:48 p.m. Eastern Standard Time at Cape Canaveral. Ludwig recorded the same event as 03:48 Universal Time on February 1. Explorer 1 was also designated Satellite 1958 Alpha. Its launcher was Juno I, the satellite-launching version of the Army's Jupiter-C, itself a modified Redstone. The Army Ballistic Missile Agency supplied the rocket, the Jet Propulsion Laboratory designed and built the satellite, and Van Allen's group at the State University of Iowa supplied the scientific instrumentation. Success required all three contributions to operate together.

The preserved data sheet makes the boundary between rocket and spacecraft unusually tangible. The instrument section and the empty casing of the small fourth-stage Sergeant rocket remained in orbit as one unit. Explorer 1 weighed 30.66 pounds, including 18.35 pounds of instrumentation. Its initial orbit ranged from a perigee of 224 miles to an apogee of 1,575 miles and took about 115 minutes. The instrument package consequently sampled a changing altitude during each circuit, rather than following a circular track at one fixed height above Earth.

Rotation performed a useful mechanical job. Four flexible whip antennas formed a turnstile arrangement and were held outward by the satellite's spin; two other antennas were built into the body. The instrument section's alternating white and dark-green strips provided passive temperature control. Their proportions were selected using the anticipated periods of sunlight and shadow. The casing, surface finish and antennas all served practical functions within a compact object whose instruments depended on batteries. Those batteries made up roughly 40 percent of the payload's weight.

Explorer 1 carried more than a cosmic-ray detector. Its instrumentation included internal, external and nose-cone temperature sensors, a microphone for micrometeorite impacts and a ring of erosion gauges. Temperature measurements monitored the spacecraft's own conditions alongside measurements of its surroundings. Two radio transmitters carried the observations to Earth: one operated at 60 milliwatts on 108.03 megacycles, the other at 10 milliwatts on 108.00 megacycles. These details in the museum data sheet connect the physical instruments with the radio signals that ground stations could receive.

Ludwig's report identifies seventeen receiving stations and separates the history of the two transmitting systems. The high-power transmitter operated until partial battery exhaustion on February 12, then briefly reappeared on February 24. The low-power system worked properly until about 07:00 Universal Time on March 16, when the batteries supplying the Geiger-Müller tube circuits became exhausted. The radiation experiment therefore had an operating history more specific than the spacecraft's final radio-signal date. NASA's mission history places the end of transmissions on May 23, 1958.

The observations also had a processing history. Ludwig described early recordings being reduced and analyzed as they arrived from the stations. His 1961 publication then presented the completed reduction of the Explorer 1 observations. One part was a master log of the recordings obtained by the network; another contained the data tabulation. That organization preserved both the measurements and the record of their reception. The initial scientific announcement preceded the completion of this larger compilation, drawing on samples of the early recordings together with observations from the next successful Explorer satellite.

Explorer 3, launched on March 26, added a tape recorder to similar radiation instrumentation. The University of Iowa explains the practical improvement: observations could be retained for an entire orbit. Explorer 1 had depended on measurements received during ground contact. The recorder extended coverage through portions of a circuit when direct reception was unavailable. Ludwig dates the announcement of a surrounding region of intense radiation to May 1, 1958, following the combination of early measurements from both spacecraft. The unexpectedly low detector counts had become part of a much larger investigation of trapped charged particles.

Later missions extended the finding. NASA distinguishes the inner belt detected with Explorers 1 and 3 from the outer belt identified with additional observations from Explorer 4 and Pioneer 3 later in 1958. The regions became known as the Van Allen radiation belts, held by Earth's magnetic field. Explorer 1 remained in orbit after its instruments fell silent, finally reentering on March 31, 1970.

The Question

Which satellite became the first successful US satellite after launching on a Juno I from Cape Canaveral on January 31, 1958?

Show the answer

The Answer

Explorer 1. Its instruments began the observations of trapped charged particles around Earth that led to the discovery of the Van Allen radiation belts.

Send this question to a friend

Read next

By clicking “Send me a stumper” you agree to On This Day Quiz’s Terms of Use and Privacy Policy.